Protec III: Original
Safety Data Sheet
Last updated: July 25, 2023
Jump to section
Safety Information:
Section 1 – Product Identification.
Section 2 – Hazard Information.
Section 3 – Chemical Composition.
Section 4 – First-Aid Measures.
Section 5 – Fire-Fighting Measures.
Section 6 – Accidental Release.
Section 7 – Handling, Care, Storage.
Section 8 – Personal Protection.
Section 9 – Chemical Properties.
Section 10 – Stability - Reactivity.
Section 12 – Ecological Information.
Section 13 – Disposal Consideration.
Section 11.
Toxicological Information.
Ingestion: All symptoms of acute toxicity are due to high alkalinity.
Skin Contact: Material will cause irritation.
Eye Contact: Material will cause severe irritation. Risk of serious damage to eyes.
Inhalation: Mist is a mild irritant to the respiratory tract. - All symptoms of acute toxicity are due to high alkalinity.
Sensitization: Not sensitizing.
Mutagenicity: No evidence of genotoxicity. In vitro/in vivo negative.
Carcinogenicity: No structural alerts.
Reproductive Toxicity: No evidence of reproductive toxicity or developmental toxicity.
STOT (Specific Target Organ Toxicity) Single Exposure: Not classified.
STOT (Specific Target Organ Toxicity) Repeated Exposure: Not classified.
Safety Data Sheet (SDS) - English Version - Section 2
Section 2.
Hazard Identification.
H319: Causes serious eye irritation.
H319: Causes skin irritation.
Safety Data Sheet (SDS) - English Version - Section 3
Section 3.
Chemical Composition.
The product composition is proprietary, but is not flammable, or hazardous, and contains no solvents or VOCs (LEED 4.1, tested to CDPH Standard Method v1.2-2017, Section 01350 standards), contains no resin, polymers, waxes, acrylics, chlorinated rubbers, or otherwise toxic, dangerous, or hazardous materials.
This product has a high pH, with an average pH of 10.9, this product is not corrosive.
Safety Data Sheet (SDS) - English Version - Section 4
Section 4.
First-Aid Measures.
This Product Is Alkaline and Drying.
P264: Wash skin thoroughly after handling.
P280: Wear protective gloves, clothing, eye and face protection.
P362: Take off contaminated clothing and wash before reuse.
P303*351*353: IF ON SKIN (Or hair) — Take off immediately all contaminated clothing. Rinse skin with water, or shower.
P337*313: If skin irritation occurs: Get medical advice or attention.
P337*338: IF IN EYES — Rinse continuously with water for several minutes. Remove contact lenses if present and easily removed, continue rinsing.
P337*313: If eye irritation persists: Get medical advice or attention.
Safety Data Sheet (SDS) - English Version - Section 5
Section 5.
Fire-Fighting Measures.
The product is not flammable, and treated materials become less flammable.
This product is a moderate flame retardant.
Safety Data Sheet (SDS) - English Version - Section 6
Section 6.
Accidental Release Measures.
This product has an average pH of 10.9, and is not toxic to wildlife.
Discharge of this product to sewage treatment is dependent on local regulations with regards to pH controls.
Use liquid-resistant gloves, protective clothing, and eye protection when handling any large spills.
If spilled on any polished metal surface, glass, or aluminum clean up immediately as etching can occur.
If spilled on clean concrete any excess product can then be applied according to our Existing Concrete Application instructions HERE, however if the concrete is not free of contaminants or salts then wash all product off with water.
Safety Data Sheet (SDS) - English Version - Section 7
Section 7.
Handling - Care - Storage.
Ensure that all opened containers are closed after opening.
Prevent contaminants from entering any containers.
This product does not need to be aggregated unless it has previously been frozen.
Safety Data Sheet (SDS) - English Version - Section 8
Section 8.
Personal Protection.
Wear protective safety glasses or disposable eye protection.
Wear disposable Nitrile gloves or gloves that are washable and that are not liquid permeable.
Limit exposure to bare skin with protective clothing to prevent any skin irritation or drying.
No respiratory protection needed during or after application.
No ventilation is needed after product application.
Safety Data Sheet (SDS) - English Version - Section 9
Section 9.
Physical Chemical Properties.
Physical State: Water-based Liquid.
pH: 10.9 - Not Corrosive.
Flashpoint: None, Not Flammable.
Product Can Freeze: Yes, Mix After Completely Melted.
Food-safe: Yes, Does Not Leach From Concrete.
VOC Content: 0g/L - LEED 4.1 Certified for Zero VOC Emissions.
Membrane Forming: Non-membrane Forming – This Product Has No Membrane Forming Ingredients, and Is Fully Compatible With Flooring or Further Coatings.
Odor: Sweet, Near Odorless.
Color: Transparent Amber Liquid. - Dries Clear.
Specific Gravity: 1.03
Solubility: Water Soluble.
Boiling Point: 100° Degrees C (212° F)
Safety Data Sheet (SDS) - English Version - Section 10
Section 10.
Stability - Reactivity.
This product will react with certain salts and chemicals while in a liquid state, however, once the product has dried it will not react.
Safety Data Sheet (SDS) - English Version - Section 11
Section 11.
Toxicological Information.
Ingestion: All symptoms of acute toxicity are due to high alkalinity.
Skin Contact: Material will cause irritation.
Eye Contact: Material will cause severe irritation. Risk of serious damage to eyes.
Inhalation: Mist is a mild irritant to the respiratory tract. - All symptoms of acute toxicity are due to high alkalinity.
Sensitization: Not sensitizing.
Mutagenicity: No evidence of genotoxicity. In vitro/in vivo negative.
Carcinogenicity: No structural alerts.
Reproductive Toxicity: No evidence of reproductive toxicity or developmental toxicity.
STOT (Specific Target Organ Toxicity) Single Exposure: Not classified.
STOT (Specific Target Organ Toxicity) Repeated Exposure: Not classified.
Safety Data Sheet (SDS) - English Version - Section 12
Section 12.
Ecological information.
Persistence and Degradability: Inorganic.
Bioaccumulative Potential: Inorganic. The substance has no potential for bioaccumulation.
Mobility In Soil: Not applicable.
Results of PBT and vPvB Assessment: Not classified as PBT or vPvB.
Other Adverse Effects: The alkalinity of this material may have a local effect on ecosystems sensitive to changes in pH.
Safety Data Sheet (SDS) - English Version - Section 13
Section 13.
Disposal Consideration.
The product packaging is general non-hazardous construction waste when packaged in pails or other bulk containers.
IBCs and other bulk containers can usually be repurposed, sold or recycled.
Safety Data Sheet (SDS) - English Version - Section 14
Section 14.
Transportation Information.
Proper Shipping Name: “Protec lll: Original”.
Waste Treatment Methods: Discharge of this product to sewage treatment is dependent on local regulations with regards to pH controls.
UN Number: Not applicable.
Transport Hazard Class: Not applicable.
Packing Group: Not applicable.
Environmental Hazards: Not classified as a Marine Pollutant.
Transport in bulk according to Annex Il of MARPOL 73/78, and the IBC Code: Not applicable.
Shipping Precautions: Ship via temperature-controlled trucks to prevent freezing if applicable.
Safety Data Sheet (SDS) - English Version - Section 15
Section 15.
Regulatory Information.
This product is not hazardous, dangerous, or toxic and is not a regulated substance or product.
Safety Data Sheet (SDS) - English Version - Section 16
Section 16.
Other Information.
Protec III: Original has the following certification:
CDPH Standard Method v1.2-2017, Section 01350.
Protec lll: Original — Safety Data Sheet (SDS/MSDS) Revision Date: July 25, 2023.
Get some product:
Cornerstone Coatings
Protec III: Original – Single Pails
Share
- Made In Canada
- VOC Free LEED 4.1
- Fast Shipping
